Publicidad
Idiomas disponibles
Idiomas disponibles
COMFORT MODE:
a) Press the Comfort mode button (Figure 13).
b) Use the (-) or (+) buttons to select the desired tem-
perature. (Example, select 22 ºC)
c) The selected temperature is saved. The existing
room temperature will be displayed again after a few
seconds.
Note: The comfort mode is recommended for a
comfortable temperature when remaining in the
room. Recommended temperature: 21 ºC.
ECONOMY MODE:
a) Press the Economy Mode button (Figure 13).
b) Use the (-) or (+) buttons to select the desired tem-
perature. (Example, Select 18 ºC)
c) The selected temperature is saved. The existing
room temperature will be displayed again after a few
seconds.
Note: This mode is recommended for long absences
from the room and is the ideal temperature for night-
time. Recommended temperature: 17 ºC.
ANTI-FREEZING MODE: :
a) Press the Anti-freezing Mode button (Figure 13).
b) Use the (-) or (+) buttons to select the desired tem-
perature. (Example, Select 7 ºC)
c) The selected temperature is saved. The existing
room temperature will be displayed again after a few
seconds.
Note: This mode is recommended for unused dwe-
llings in extremely cold climates. Recommended
temperature: 5 ºC.
Important: If the selected temperature is higher than
that of the room the heater will start operating (the
flame symbol will be displayed
5.6 Switching off
The heater operation can be disconnected by pres-
sing the "Standby" button (Fig. 13). The heater can
be permanently switched by the ON/OFF switch at
the rear of the unit.
5.7 Automatic Use (Programmed)
Taking into account your personal needs, the heater
provides the possibility to create an individual pro-
gramme. This programme is established according
to the day, time and operating modes: comfort, eco-
nomy, anti- icing or standby mode.
1. If the heater is in Standby (Fig.18), press the "Stan-
dby" button to switch it on stand-by.
2. Press the "PROG" button for three seconds. The
four clock digits will be displayed. First, the two
"hour" digits will flash. Use the (+) or (-) buttons to
enter the current hour. Then, press "PROG" to pro-
gramme the minutes. Enter the current minutes.
Press the "PROG" button.
3) Then, programme the current day of the week. All
the following digits will be displayed, "1, 2, 3, 4, 5,
6, 7". Use the (+) or (-) buttons to enter the day of
the week as follows (1 = Monday, 2 = Tuesday etc).
Press the "PROG" button.
4. Programming each day of the week. Begin by pro-
gramming the first band for Monday (1) From 00:00
hours until 01:00 (the first bands will flash). An opera-
ting mode can be assigned to each hour:
- To programme comfort, press the "Comfort" button:(-
Comfort Mode = one double bar).
Double bar
- To programme economy, press the "Economy" but-
ton (Economy Mode = one single upper bar).
Single upper bar
- To programme "Anti-icing", press the "Anti- icing"
button. (Anti-icing Mode = one single upper bar).
Single lower bar
EN
www.garsaco.com | 15
Publicidad
