Publicidad
Idiomas disponibles
Idiomas disponibles
EN
PANTALLA LCD
Consumption indicator:
This appears when the heater is consuming power,
in other words, in operation.
Temperature indicator:
1. Ambient temperature: that of the room, it is dis-
played on all screens by default.
2. Assigned temperature: that selected by the user
as the desired temperature for comfort mode, eco-
nomy mode or anti-frost mode. To display this tem-
perature press the (-) or (+) button.
OPERATION
1. Your heater is fitted with a digital, daily- program-
mable timer-thermostat that controls and adjusts the
heating.
2. The heater can be used to two ways, either ma-
nually or automatically. It is fitted with a daily timer for
each day of the week.
IMPORTANT: The temperature indicated on the
screen may differ from that given by another thermo-
meter in the same room. Different conditions such
as air currents, windows etc, could cause these
differences.
5.1 Putting into operation
1. When the heater is installed and connected to the
mains power, press the ON/ OFF switch, which is
located at the right rear part of the unit.
2. The LCD screen will light up and all the symbols
will flash several times.
3. Then the operating mode just before the last
switch-off appears (stand-by, manual or automatic),
together with the approximate room temperature.
14 | www.garsaco.com
Mode Standby
Fig.15
Manual Mode
(example: Comfort Mode)
Fig.16
Automatic Mode
Fig.17
4. When in "Standby" mode (Fig. 15), press the
"Standby" button to switch the heater on (Figure 13).
The heater comes on and the last selected operating
mode symbol appears on the screen. In addition,
the approximate room temperature is displayed. If
the heater is switched on in manual (Fig. 16) or auto-
matic mode (Fig. 17) the unit is already in operation.
5.2 Locking / Unlocking
The heater controls will automatically lock when no
button has been pressed for sixty seconds. This
operation will occur in both manual and automatic
modes. The heater controls can be unlocked by
pressing the "+" and "-" buttons on the control pa-
nel for three seconds (Figure 13) or on the remote
control.
Note: After unlocking the keypad, the selected
temperature will appear for three seconds with ºC
flashing.
5.3 Using the heater
The heater can operate in manual or automatic
mode (programmed).
5.4 Manual Use
To select manual mode, press the "PROG" key un-
til the tim e bands disappear from the LCD screen
(Figure 18).
Modo Stand by
Fig.18
5.5 Changing the selected temperature
The heater is supplied with a pre-established tem-
perature for each operating mode, which can be
modified in the following manner:
Publicidad
