Descargar Imprimir esta página

After Finishing Work; Preparing For Transportation Or Storage; Transporting The Chain Saw And Battery; Chain Saw - Stihl MSA 220 C Manual De Instrucciones

Ocultar thumbs Ver también para MSA 220 C:

Publicidad

Idiomas disponibles

Idiomas disponibles

English
► Switch on the chain saw, @ 18.1.
The chain should throw off a small amount of oil.
If the chain oil cannot be seen, check the oil level and refill
the tank as necessary.
► Test the chain lubrication again.
► If chain lubrication oil is still not visible, the lubrication
mechanism is not functioning. Take the saw to an
authorized STIHL servicing dealer to be repaired before
use.

20 After Finishing Work

20.1 Preparing for Transportation or Storage

WARNING
To reduce the risk of personal injury from unintended
activation or unauthorized use, switch off the chain saw,
engage the chain brake and remove the battery before
transporting the chain saw or putting it down. To reduce the
risk of injuries from the sharp cutters on the chain, always
cover the guide bar with the chain scabbard before
transporting or storing the saw.
To prepare the saw for transportation or storage:
► Switch off the chain saw, @ 18.2.
► Engage the chain brake, @ 16.1.
► Remove the battery, @ 17.2.
► Release the chain brake and loosen the chain.
► Re-engage the chain brake.
► Slide a chain scabbard over the guide bar so that it covers
the entire guide bar.
► If the battery or chain saw became wet during operation,
allow them to dry separately and completely before
charging or storing.
► Before using the saw, remember to re-tension the chain.
48
NOTICE
The chain contracts as it cools down. Failing to loosen the
chain after finishing work can damage the drive shaft and
bearings.
21 Transporting the Chain Saw and
Battery

21.1 Chain Saw

When transporting the chain saw:
► Slide a chain scabbard over the guide bar so that it covers
the entire guide bar.
► When transporting the saw by hand, hold it by the front
handle with the guide bar pointing backwards, opposite
the direction in which you are walking.
► When transporting the saw in a vehicle, cover the guide
bar with a chain scabbard. Secure and position the chain
saw to prevent turnover, impact and damage.
Your saw comes standard with a chain scabbard that
matches the cutting attachment. If you use guide bars of
different lengths on the saw, the length of the chain
scabbard must be matched to the guide bar to reduce the
risk of injury. It should cover the full length of the guide bar.
20 After Finishing Work
0458-795-8621-C

Publicidad

loading