Duux Whisper DXCF03 Manual De Instrucciones página 11

Operating instructions
Remove the parts from the packaging
1
and assemble the device according to the
instructions in this manual.
Connect the power cable to the input terminal
2
in the base of the product. Then insert the plug
into the wall socket. The control ring will light
up and show the standby indicator.
Press the control ring once, to turn the product
3
on. The fan springs into life and will thereafter
default to the most recent speed setting.
Use the stainless steel exterior of the control
4
ring to switch between settings.
When a display icon is flashing, you can set and
5
Power
Fan speed
down
Timer down
Horizontal oscillation
Natural wind
Comfort
Fan speed up
Fan
Timer up
Timer
Vertical oscillation
Swing
Night mode
Night
adjust this setting by pressing the control ring.
When the desired position is reached, press
the control ring again to confirm the selection.
When setting the fan speed and timer function,
6
the LCD display will continue to flash until the
desired setting is selected. After this, press the
control ring again to confirm the selection.
Once the function is set, the icon will stop
7
blinking and will remain visible in the display,
for as long as this function is set to on.
Press the control ring for a few seconds to
8
switch off the appliance.
Note: When using the remote, be sure to point
it directly at the remote sensor on the device and
remove any obstacles that may be in the path
between the remote and the device.
Note: To replace or remove the battery, push
the tab lock on the bottom edge of the remote
to the left and hold it. While holding the tab to
the left, pull the tray out of the remote. Remove/
replace the battery and make sure to place the
new battery with the + symbol pointing towards
you. Place the tray back in the remote.
11