Publicidad
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do
so could result in electric shock or personal injury from cleaner suddenly starting.
el
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
d.
Operating Instructions, should be performed by an authorized service
representative.
d
PROBLEM
Cleaner won't start.
n
Poor job of dirt
pick-up.
Cleaner starts but
cuts off.
ctor
d of
Cord won't rewind.
into
Nozzle picks up
movable rug.
Nozzle hard to push
on carpet.
en
m
a.
All manuals and user guides at all-guides.com
BEFORE REQUESTING SERVICE
WARNING
POSSIBLE CAUSE
1. Unplugged at wall outlet.
2. Tripped circuit breaker/blown fuse
at household service panel.
3. Tripped thermal protector in canister.
1. Full or clogged dust bin.
2. Clogged airflow passages.
3. Dirty filters.
4. Wrong floor nozzle setting.
5. Open suction control.
6. Hole in hose.
7. Dirty brushes.
8. Dust bin open.
1. Tripped thermal protector.
1. Dirty power cord.
2. Cord jammed.
1. Suction too strong.
1. Wrong nozzle setting.
Electric Shock or Personal Injury Hazard.
POSSIBLE SOLUTION
1. Plug in firmly, push ON/OFF switch to ON.
2. Reset circuit breaker or replace fuse.
3. Reset thermal protector.
1. Empty dust bin.
2. Clear airflow passages.
3. Clean filters.
4. Adjust setting.
5. Adjust control.
6. Replace hose.
7. Clean brushes.
8. Close dust bin.
1. Reset thermal protector.
1. Clean the power cord.
2. Pull out cord and rewind.
1. Adjust suction control setting
1. Adjust setting.
- 21 -
Publicidad
