Descargar Imprimir esta página

Starting A Washing Programme - Kunft KDW4752 Manual De Instrucciones

Publicidad

Idiomas disponibles

Idiomas disponibles

- Soften remnants of burnt food in pans
When loading the dishes and cutlery, please note the
following:
Dishes and cutlery must not impede the rotation of the spray arms.
Load hollow items such as cups, glasses, pans etc. with the opening
downwards so that water cannot collect in the container or a deep
base.
Dishes and items of cutlery must not lie inside one another, or cover
each other
• To avoid damage to glasses, they must not touch
• Load large items which are most difficult to clean into the lower rack
• The upper basket is designed to hold more delicate and lighter
dishware such as glasses, coffee and tea cups
Attention!
Long bladed knives stored in an upright position are a potential
hazard!
Long and/or sharp items of cutlery such as carving knives must be
positioned horizontally in the upper basket.
Damage to glassware and other dishes
Possible causes:
• Type of glass or manufacturing process. Detergent's chemical
composition.
• Water temperature and duration of the dishwasher programme.
Suggested solution:
• Use glassware or porcelain dishes that have been marked
dishwasher-safe by the manufacturer.
• Use a mild detergent that is described as delicate on dishes. If
necessary, seek further information from detergent manufacturers.
• Select a low temperature programme.
• To prevent damage, take glasses and cutlery out of the dishwasher
as soon as possible after the programme finishes.
At the End of the Wash
When the working cycle has finished, the digital display "---", then
stop. Turn off the appliance using the Power button, shut off the water
supply and open the door of the dishwasher. Wait a few minutes
before unloading the dishwasher to avoid handling the dishes and
utensils while they are still hot and more susceptible to breakage.
They will also dry better.
26
dishwasher

Starting a washing programme

Washing programme table
Programme Cycle Selection
Description of
Information
Cycle
For the heaviest soiled
Pre-wash
loads, such as pots,
Main wash (60ºC)
pans, casserole dishes
Intensive
Rinse1
and dishes that have
Rinse2
been sitting with dried
Hot rinse Drying
food on them for a while.
For normally soiled
Pre-wash
loads, such as pots,
Eco
Main wash (44º C)
plates, glasses and
(*EN50242)
Hot rinse
(Standard
lightly soiled pans.
Drying
Programme)
standard daily cycle.
For lightly and normally
Pre-wash
soiled plates and pans
Main wash (50º C)
for every day. Run cycle
Rinse
immediately after use)
Hot rinse Drying
A shorter wash for lightly
Main wash (40º C)
soiled loads that do not
Hot rinse
need drying.
To rinse dishes that
Pre-wash
you plan to wash later
that day
Pre-Rinse
Turning on the appliance
Starting a washing programme...
Pull out the lower and upper basket, load them with dishes and
proceed accordingly:
1. Push them back. It is recommended to load the lower basket first,
then the upper one (refer to section "Loading the Dishwasher").
Pour in the detergent.
2. Insert the plug into the socket. The power supply is 220-240 V
AC 50 Hz, the specification of the socket is 12 A 250 VAC, 50 Hz.
Make sure the water supply is turned on to full pressure. Close the
door, press the ON/OFF button, press the "programme" button to
select a desired "Washing programme" (refer to section "Washing
programme Table").
Apply a little force to ensure the door is properly closed.
NOTE: a click will be heard when the door is properly closed.
When the washing is over, you can switch off the appliance by
pressing the ON/OFF button.
EN
KDW4752
Detergent
Running
Energy
Water
Pre/main
Time
(kWh)
(min)
5/25 g
180
1.300
(or 3in1)
5/25 g
237
0.900
(or 3 in 1)
5/20 g
90
0.890
15 g
30
0.500
/
11
0.010
27
(L)
16
11
14
7
4

Publicidad

loading