Filtering System - Kunft KDW4752 Manual De Instrucciones

Switching on
1. Open the tap, if it is closed.
2. Close the door.
3. Make sure the spray arms are not obstructed.
4. Switch the dishwasher on using the " Start/Pause " button.
Cancel/Change the program
Note: a cycle that is underway can only be modified if it has only
been running for a short time. Otherwise, the detergent may have
already been released, and the appliance may have already drained
the wash water. Should this be the case, the detergent dispenser
must be refilled (refer to section "Fill in the Detergent").
Open the door and press the power button for more than 3 seconds
to turn off the machine and cancel the program. When you restart the
machine, you can change the program to the desired cycle setting
(refer to section "Starting a washing programme").
NOTE: if you open the door during a washing programme, the
machine pauses, a warning alarm will ring and the display will show
E1. When you close the door, the dishwasher will resume working.
Forget to add a dish
Dishes can be added any time before the detergent container opens.
1. Slightly open the door to stop the washing programme.
2. After the spray arms stop working, open the door completely.
3. Add the dishes.
4. Close the door. The dishwasher will resume work after 10 seconds.
WARNING!
It is dangerous to open the door when washing, as hot water may
scald you.
Switch Off the Dishwasher
The digital display shows "--", only in this case the programme has
ended.
1. Switch off the dishwasher by pressing the ON/OFF button.
2. Turn off the water tap!
28
dishwasher
2.3. Maintenance

Filtering System

The filter is used to avoid large residues
and other sundries from getting inside the
pump, as they can obstruct the filter.
The filter system consists of a coarse
filter, a flat (main filter) and a micro filter
(fine filter).
1. Flat filter
Food and debris will be trapped by a
special jet on the lower spray arm.
2. Coarse filter
Larger debris, such as bone and glass that could clog the drain, will
be trapped in the coarse filter.
To remove an item caught in this filter, gently squeeze the taps on
the top of this filter and lift it out.
3. Micro filter
This filter holds soil and food residue in the sump area and
prevents it from being redeposited on the dishes during a washing
programme.
- Inspect the filters for obstructions after each use of the
dishwasher.
- By unscrewing the coarse filter, you can remove the filter system.
Remove any food remnants and clean the filters under running
water.
Step 1. Rotate the coarse
filter counter-clockwise
and lift it up.
Step 2: Lift the flat filter.
NOTE: If operate from step 1 to step 2, the filter system will be
removed; while operate from step 2 to step 1, the filter system will
be installed.
Filter assembly
For best performance and results, the filter assembly must be
cleaned. The filter efficiently removes food particles from the wash
water, allowing it to be recirculated during the cycle. For this reason,
it is a good idea to remove the larger food particles trapped in the
29
EN
KDW4752