Troubleshooting - Kunft KDW4752 Manual De Instrucciones

Attention:
The installation of the pipes and
electrical equipment should be done by
professionals.
Disconnect the electrical power before installing dishwasher. Failure
to do so can result in death or electrical shock.
WARNING!
The packaging material could be dangerous for children!
Dispose of package and of the appliance at a recycling centre. Cut off
the power supply cable and make the door closing device unusable.

2.4. Troubleshooting

ERROR CODES
In the event of a malfunctions, the appliance will display the following
error codes:
Codes Meanings
E1 Door open
E2 Water inlet
E3 Water drainage
E4 Temperature sensor Temperature sensor malfunction
E5
Overflow / leakage
E6 Water leakage
E7 Heating element
WARNING!
In case of overflow, turn off the main water supply before calling the
Customer Support Service. If there is water in the base pan due to an
overfill or a small leak, the water should be removed before restarting
the dishwasher.
Warning
Electrical Shock
Hazard!
Possible Causes
The door is open when the
dishwasher is working
Water inlet malfunction
Water drainage malfunction
Overflow / Water leakage occurs
Water leakage occurs
Abnormal heating
32
dishwasher
Before calling the Customer Support Service
Refer to the following charts before calling the Customer Support
Service, as many issues can be solved without recourse to external
services.
Problem Possible causes
Dishwasher Fuse blown or the
doesn't work circuit breaker acted
Power supply is not
turned on
Water pressure is low
Drain pump Overflow
doesn't stop
Noise Some audible sounds
are normal
Utensils are not
secure in the racks or
something small has
dropped into the rack
Motor is humming
Suds in Improper detergent
the tub
Spilled rinse agent
33
EN
KDW4752
How to proceed
Replace the fuse or reset the
circuit breaker. Remove any other
appliances sharing the same
circuit with the dishwasher.
Make sure the dishwasher is
turned on and the door is properly
closed. Make sure the power cord
is properly plugged into the wall
socket.
Check that the water supply is
properly connected and the water
is turned on.
The system is designed to detect
an overflow. When it does, it shuts
off the circulation pump and turns
on the drain pump.
Sound from detergent container
opening.
Ensure everything is secured in
the dishwasher.
The dishwasher has not been
used regularly. If you do not use it
often, remember to set it to fill and
pump out every week, which will
help keep the seal moist.
Use only a special dishwasher
detergent to avoid suds. Should
this occur, open the dishwasher
and let suds evaporate. Add 1
gallon of cold water to the tub.
Close and latch the dishwasher,
then start the "pre-rinse" washing
programme to drain out the water.
Repeat if necessary.
Always wipe up rinse agent spills
immediately.