WIRED CONTROLLER OPERATION
Heater Button
Bubble Button
- Adjust the bubble level by pressing
the button (L1:300W, L2: 500W, L3:720W)
Up Button
Celsius/Fahrenheit
Toggle Button
Temperature display: press RESET on PRCD, read the current temperature on the screen.
Heater Button:
The filter will automatically be running for 15 seconds to test the working condition once the HEATER
HEATER
function is started. If there is no abnormality, the heater will keep working until the water temperature
reaches the set value. When the water temp goes below the set temp, the heater will restart to heat
the water automatically. The HEATER button displaying red means that the heating system is
activated. The HEATER button displaying green means that the system is at rest and keeping the
water at the set temp.
Filter Button:
green when activated.
FILTER
NOTE: Filtration cannot be turned off when heating function is on (Whether the heater is running or at
rest) . When the Heating function is turned off, filtration will be stopped after 30 seconds. Filtration
function can then be activated separately.
NOTE: The auto-filtration system is automatically activated every 4 hours.
Bubble Button:
power is at level 2 (500W). Press the BUBBLE button again, switching to level 3 (720W). Press again
BUBBLE
to enable level 1 (300W). To shut down the function, press the BUBBLE button for 3 seconds.
NOTE:
The bubbling massage function will be shut down automatically after every 20 minutes
operation for safety concern. It cannot be operated within 10 minutes after shutting down.
Press HEATER button to start or stop heating.
Press FILTER button to turn the function on/off. The light of FILTER button displays
Can adjust among 3 levels of bubbling power. The default bubbling massage
17
Filter Button
Timer Button
Down Button
Ozonator Button