Attention:
The bubble function can only be activated when the inflation knob is in <OFF> position.
Adjustment Buttons:
the temperature within 3 seconds. Otherwise the temperature setting mode will end automatically. If
UP
the other button is pressed during the setting , the setting will also stop. The current temperature
shown on the screen is confirmed.
DOWN
NOTE: Default setting temperature is 38°C; Temperature setting range: 20 - 40°C.
Controller Locking: Press UP and DOWN button at the same time for 3 seconds, the buzzer will ring
3 times, meaning that the controller is locked. In this mode, the function will not be turned on if the
button is pressed. Press UP and DOWN button at the same time again for 3 seconds to unlock the
controller.
Timer Button:
and DOWN button, you can set and start heating automatically with in up to 99 hours. The TIMER
TIMER
setting is confirmed if no further operation in more than 3 seconds or press TIMER button again. The
heater will start working after current setting hours. The setting hour can also be changed by entering
the pre-setting mode again. The light of TIMER button flashes green when activated.
Cancel: Press the TIMER button for 3 seconds to cancel the pre-setting.
NOTE: The pre-setting function cannot be turned on during heating process. The pre-setting mode
will also end once the heating function is on or after the spa is reboot.
Celsius/Fahrenheit Toggle Button:
Fahrenheit.
Ozonator Button:
activated. For bathers' safety concern, the ozonator cannot be operated at the same time when the
Bubbling or Jet function is on. The Ozonator will be off automatically after operating for 2 hours. The
ozone output is 30-50mg/Hr.
NOTE:
Please do not soak in the spa when the Ozone is on. The Ozonator will not work when the
spa has no water or when the Bubble Button is on. The filtration cannot be turned off when Ozonator
is in use.
Filter Cartridge Cleaning Reminder: When the red light keeps flashing (Filter
function is OFF) or red and green lights are alternately flashing(Filter function is
ON), the filter cartridge shall be cleaned or replaced. After that, press Filter button
for 3 seconds to clear the reminder.
IMPORTANT: The following conditions will lead to slow water heating
● The ambient temperature is lower than 10°C(50°F)
● Outdoor wind speed is above 3.5-5.4m/s(8-12mph)
● The air bubble function is activated when heater is on
● The spa is not properly covered with the spa cover when the heater is on
Press UP or DOWN button, the screen flashes setting temperature. Re-set
Press the TIMER button to enter the intelligent pre-setting mode. By pressing UP
Activate the Ozone. The Ozone icon shows green when the Ozone function is
The temperature can be displayed in either Celsius or
18