Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1:
Move the engine ON/OFF switch to the
OFF position.
STEP 1:
Insert suction tube into 0.5 gallons (1.8 L) of
fresh water.
Siphon water at low pressure for one min-
ute to clear the line of residual detergent.
STEP 2:
Move the engine on/off switch to the OFF
position.
STEP 3:
Turn off the water source.
STEP 4:
Press trigger to release water pressure.
It is highly recommended to use Kärcher's
Pump Guard (part number 9.558-998.0 sold
separately) before winter storage and during
the cleaning season to protect the pump from
freezing and premature wear.
STEP 1:
Move engine ON/OFF switch to OFF position.
STEP 2:
Disconnect all hoses.
STEP 3:
Unscrew cap from Pump Guard bottle.
STEP 4:
Remove internal seal.
STEP 5:
Reattach cap to Pump Guard bottle and
remove black protective cap.
12
TAKING A BREAK ...five minutes or more
SHUTTING DOWN & CLEAN-UP
WINTERIZING AND LONG-TERM STORAGE
STEP 2:
Release trigger and engage safety lock.
STEP 5:
Release trigger and engage gun safety lock.
STEP 6:
Disconnect the garden hose from the water
inlet on the unit.
STEP 7:
Disconnect the high pressure hose from the
high pressure outlet. Store the high pressure
hose in the hose holder strap.
STEP 6:
Screw bottle into water inlet on pressure
washer pump and squeeze until fluid starts
to exit tue pump
STEP 7:
Pull starter handle until fluid starts to exit the
pump's high pressure outlet
STEP 8:
Unscrew bottle. Store or dispose properly
CAUTION
Failure to follow the above directions may
result in damage to the pump assembly and
accessories and void the warranty.
.
Publicidad
