Working With Detergent; Interrupting Operation - Kärcher K 4.800 eco!ogic Manual De Instrucciones

Operation
Caution
Prior to cleaning, make sure that the high
pressure is placed safely on level ground.
Wear protective goggles and protective
clothing during the cleaning process.
 Illustration
Push the spray lance into the trigger
gun and fasten it by turning it through
90°.
 Set the appliance switch to "1/ON".
Danger
The handgun is subjected to a recoil force
when the water jet is discharged. Make
sure that you have a firm footing and are
also holding the handgun and spray lance
firmly.
 Pull on the lever of the trigger gun; the
device will switch on.
Note: Release the lever of the trigger gun;
the device will switch off again. High pres-
sure remains in the system.
Spray lance with pressure regulation
Carrying out the most common cleaning
tasks. The work pressure can be infinitely
regulated between "Min" and "Max".
 Release the lever on the trigger gun.
 Turn the spray lance to the desired po-
sition.
Suitable for working in switch position
–
"eco".
Note: Suitable for working with detergent;
for this, turn the spray lance to the "Mix" po-
sition.
Spray lance with Dirtblaster
For particularly dirty items or areas.
Caution
Car tyres, paint or sensitive surfaces such
as wood should not be cleaned with the dirt
blaster, as there is a risk of damage.
Not suitable for use with detergents.
–
The Dirtblaster reaches its maximum
–
cleaning performance in standard
mode.
20
All manuals and user guides at all-guides.com
EN

Working with detergent

Please use exclusively KÄRCHER deter-
gents and care products to carry out the re-
spective cleaning task, as these were
specifically developed for your appliance.
The use of other detergents and care prod-
ucts may lead to premature wear and can
invalidate your warranty claims. Please ob-
tain information at your local dealer or re-
quest information directly from KÄRCHER.
Notes regarding the detergent: The most
commonly used KÄRCHER detergents can
be purchased ready to use in their Plug 'n'
Clean detergent bottles with locking lids.
This will make the pesky refilling and filling
processes redundant.
 Illustration
Remove the lid from the Plug 'n' Clean
detergent bottle and press the deter-
gent bottle into the detergent connec-
tion with the opening facing down.
 Illustration
Adjust the suction volume of the deter-
gent solution by means of the dosage
regulator for detergents.
 Use spray lance with pressure regula-
tion (Vario Power).
 Turn the spray lance to "Mix" position.
Note: This will mix the detergent with
the water stream.
Recommended cleaning method
 Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
 Spray off loosened dirt with the high
pressure jet.

Interrupting operation

 Release the lever on the trigger gun.
 Lock the lever on the trigger gun.
 During longer breaks (more than 5 min-
utes), also turn the appliance off using
the "0/OFF" switch.
 Insert the trigger gun in its holder.
– 10