Operating Instructions; Intended Use; Assembly And Operation - Worx WX177 Traducción De Las Instrucciones Originales

noise emission value may also be used in a preliminary
assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
12
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
Recommended pilot-hole size for Screws
Ø
Ø
1.5mm
Ø
Ø
20V Cordless Brushless
SWITCHDRIVER 2.0
3mm 3.5mm 4mm
2mm 2.5mm
5mm 6mm
3mm 3.5mm 4mm/5mm
4. OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The machine is intended for drilling (including pilot
hole) in wood, metal and plastic as well as for driving
and removing fasteners.

ASSEMBLY AND OPERATION

STARTING THE MACHINE FOR THE
FIRST TIME
Removing the Battery Pack
Charging the Battery Pack
More details can be found in charger's
manual
Installing the Battery Pack and Starting
the Machine
As you install the battery pack, the LED
light will turn on, the light turns on, a
boot screen will appear. After a while,
the screen will show number"1".
PREOPERATION SETUP
Installing a 6.35mm hex SCREWDRIVING
bit
The machine is ideally inserted with one
drilling bit and one screw driving bit.
After you start the machine for the first
time, the default mode is screw driving
at torque level 1.
Insert a 6.35mm hex SCREWDRIVING
bit into
4.5mm
the chuck locking sleeve.
Installing the DRILL bit
3mm
Place forward/reverse rotation control in
the middle position, push the dual chuck
release button to the bottom and rotate
the dual chuck . The light goes off and
8mm
the light turns on.
Insert a 6.35mm hex DRILL bit into the
other
chuck locking sleeve.
Rotating the dual chuck enables the
working mode to the corresponding bit.
ACTION FIGURE
See Fig. A1
See Fig. A2
See Fig.
A3,A4
See Fig. B1
See Fig.
B2,B3
See Fig. C
EN