Using The Water Fountain; Filling The Water Tank Of The Water Fountain; Cleaning The Water Tank - Beko GN1603140XBN Manual Del Usuario

Using the product

6.7 Using the water fountain

*May not be available in all models
C
The first few glasses of water taken from
the fountain will normally be warm.
C
If the water fountain is not used for a long
time, dispose of the first few glasses of
water to get clean water.
1. Push the arm of the water fountain with your
glass. It would be easier to push the arm with
your hand if you are using a soft plastic glass.
2. Release the arm after filling your glass with
water as you desire.
C
The amount of water flow from the
fountain depends on the pressure you
apply on the arm. Release the pressure
on the arm slightly as the water level
in your glass/container is increased to
prevent overflow. Water shall drip if you
press the arm slightly; this is normal
and it is not a malfunction.
6.8 Filling the water tank of
the water fountain
Open the lid of the water tank as shown in the
figure. Fill in pure and clean drinking water.
Close the lid.

6.9 Cleaning the water tank

Remove the water filling reservoir inside the door
shelf.
Detach by holding both sides of the door
shelf.
Hold both sides of the water tank and remove at
45° angle.
Remove and clean the water tank lid.
22 /31 EN
Refrigerator / User Guide