Connection To Vbus.nEt; Configuration For Rpt - Resol DL2 Plus Manual

5.2.2 Connection via WLAN
Controller DL2 Plus
For further information, see:
chap. 3.3 (W)LAN connection on page 27
chap. 1 Overview on page 25
chap. 7.21 Network configuration on page 37
chap. 7.25 Configuring the remote access on page 38
5.3

Connection to VBus.net

For the connection to VBus.net, the datalogger requires an Internet connection (via
LAN or WLAN) as well as a VBus.net account.
In order to access a datalogger via VBus.net, proceed as follows:
1. Note down the alphanumeric 8-10-digit code (Token) indicated on the under-
side of the housing.
2. Enter VBus.net into the address bar of the browser and click Sign up.
3. Wait for the confirmation e-mail (check spam folder if necessary).
4. Click Add new device.
5. Enter the alphanumeric 8-10-digit code (Token).
For further information, see:
chap. 3.3 (W)LAN connection on page 27
chap. 1 Overview on page 25
chap. 7.25 Configuring the remote access on page 38
5.4 Configuration for RPT
In order to use RPT, VBus.net access over the local network has to be ena-
bled, see chap. 7.25 on page 38.
30
www
Router
Internet device
5.4.1 Using RPT without VBus.net
In order to use RPT without VBus.net, proceed as follows:
1. Download and install the software.
2. Select the Communication menu.
3. Click Connect.
4. Select the DL2 Plus interface.
5. Select the channel.
Channel 1 = terminals 1 / 2
Channel 2 = terminals 2 / 3
6. Enter the URL/IP address.
7. Enter the password into the Password field.
8. Click Connect.
5.4.2 Using RPT via VBus.net
In order to use RPT via VBus.net, Remote access over Internet has to be ena-
bled, see chap. 7.25 on page 38.
With a VBus.net account you can easily use RPT in order to parameterise the
controller over the Internet:
1. In the VBus.net menu My Devices, click on Edit.
2. On the General settings page, tick the option Allow parameterization
using the via address and the RESOL Parameterization Tool (RPT).
3. Download and install the software.
4. Select the Communication menu.
5. Click Connect.
6. Select the DL2 Plus interface.
7. Select the channel.
Channel 1 = terminals 1 / 2
Channel 2 = terminals 2 / 3
8. Enter the via tag from the VBus.net menu item General settings into the RPT
field URL/IP.
9. Enter the password into the Password field.
10. Click Connect.