ARC'TERYX BORA PACK Manual Del Usuario página 25

INSTALLING THE HIPBELT
WARNING! Always ensure that the TPU bumper on the
RotoGlide™ slider of the hipbelt is inserted into the rails towards the
top of the pack. This TPU bumper prevents the rail and slider from
making a clicking noise each time they touch while using the pack.
STEP 1
Lay the pack on a flat surface with the back panel facing you, hold
the hipbelt and orient the RotoGlide
is inserted first into the rails.
STEP 2
Push the slider into the rail until you hear a click, as it completely
passes the latch.
STEP 3
Test your installation:
• Make sure the slider moves freely along the back panel
towards its top and bottom
• Make sure it's securely attached. If you lift the hipbelt,
the pack should lift too.
STEP 4
Thread the webbing through the hipbelt load stabilizer buckles on
both sides of the hipbelt, the same way they were unthreaded.
Make sure there are no twists in the webbing.
slider so that the TPU bumper
™
24