Setting The Axial Cutting Depth - Expondo MSW-EPR-710 Manual De Instrucciones

IMPORTANT: wait until the cutting head has come to a complete stop
before storing the machine or adjusting it. Do not touch the cutting
head under any circumstance during this time!
3.3.3

Setting the axial cutting depth

CAUTION: Be careful - risk of injury. The machine must be
disconnected from the power supply.
Lay the machine on its side. Press the axis lock button (J) as far as it
will go and, at the same time, use the accompanying Allen key to turn
the cutting head until it locks (the axis lock button will go all the way
in). Then use the same wrench to turn the adjustment knob (I) to the
desired depth - pay attention to the position of the dot on the knob
(I) relative to the marked scale on the head (adjustment range: 0-
0.3mm.