Danfoss VLT Midi Drive FC 280 Guia De Instalacion página 8

VLT® Midi Drive FC 280
HAZARDOUS VOLTAGE
AC drives contain hazardous voltage when connected to the AC mains or connected on the DC terminals. Failure to perform
installation, start-up, and maintenance by qualified personnel can result in death or serious injury.
-
Only qualified personnel can perform installation, start-up, and maintenance.
DISCHARGE TIME
The drive contains DC-link capacitors, which can remain charged even when the drive is not powered. High voltage can be
present even when the warning indicator lights are off. Failure to wait the specified time after power has been removed before
performing service or repair work can result in death or serious injury.
-
Stop the motor.
-
Disconnect all power sources, including permanent magnet type motors.
-
Wait for capacitors to discharge fully. The discharge time is shown on the nameplate. See
the Contents.
-
Verify full discharge by measuring the voltage level.
UNINTENDED START
When the drive is connected to the AC mains or connected on the DC terminals, the motor can start at any time, causing risk of
death, serious injury, and equipment or property damage.
-
Stop the drive and motor before configuring parameters.
-
Ensure the drive cannot be started by external switch, a fieldbus command, an input reference signal from the control panel,
or after a cleared fault condition.
-
Disconnect the drive from the mains whenever safety considerations make it necessary to avoid unintended motor start.
-
Check that the drive, motor, and any driven equipment are in operational readiness.
INTERNAL FAILURE HAZARD
An internal failure in the drive can result in serious injury when the drive is not properly closed.
-
Ensure that all safety covers are in place and securely fastened before applying power.
ELECTRICAL SHOCK AND FIRE HAZARD
The drive can cause a DC current in the ground conductor. Failure to use a Type B residual current-operated protective device
(RCD) can lead to the RCD not providing the intended protection which can result in death, fire, or other serious hazard.
-
Use an RCD device.
-
When an RCD is used for protection against electrical shock or fire, use only a Type B device on the supply side.
4 | Danfoss A/S © 2022.06
W A R N I N G
W A R N I N G
W A R N I N G
C A U T I O N
W A R N I N G
1.1.5 Verifying the Shipment and
AN41533976851001-000101 / 130R1257