Important Recommendations - Rowenta DA1510 Manual De Instrucciones

IMPORTANT RECOMMENDATIONS

• Always plug your iron into an earth socket. Connecting to the wrong
voltage may cause irreversible damage to the iron and will invalidate the
guarantee.
• If you are using a mains extension lead, ensure that it is corrected rated
(16A) with an earth, and is fully extended.
• Do not unplug your appliance by pulling on the cord.
• Never immerse your steam iron in water or any other liquid. Never hold it
under the water tap.
• Never touch the electric cord with the soleplate of the iron.
• Your appliance gives off steam, which may cause burns, especially when
you are ironing close to the edge of your ironing board.
• Never direct the steam towards people or animals.
• For your safety, this appliance conforms to the applicable standards and
regulations (Low Voltage, Electromagnetic Compatibility, Environmental
Directives).
• This product has been designed for domestic use only. Any commercial
use, inappropriate use or failure to comply with the instructions, the
manufacturer accepts no responsibility and the guarantee will not apply.
ENVIRONMENT PROTECTION FIRST !
Your appliance contains valuable materials which can be recovered or
i
recycled.
Leave it at a local civic waste collection point.

IRON'S DESCRIPTION
1.
Voltage selector
(120/240 V)
2.
Temperature control
3.
Steam switch
4.
High precision tip
Problems
and possible causes
• The temperature selected is too low.
• The steam control is set on OFF.
• There is no water in the tank
• You have been using the burst of
steam button too often.
• Steam is used before the iron is hot
enough.
• The iron is stored with water in th
tank.
Keep these instructions
Your iron produces little or no steam
.
Water is dripping from the holes in the soleplate
(see sketch on Page 1)
5.
Microsteam200 soleplate
6.
Handle water tank
7.
Water filling inlet
8.
Burst of steam button
9.
Handle release
Set the temperature control on •••
Switch the steam control to ON.
Fill the water tank.
Wait a few seconds between each shot.
Set the thermostat within the coloured
steam zone and wait until the iron is hot
(approx. 2 min.).
Empty the tank before storing the iron
and set the steam control to OFF.
2
Solutions