System Schematic Diagram; Install Chlorine/Bromine Feeders After The Intellichlor Scg Cell - Pentair INTELLICHLOR IC15 Guía De Instalación Y Usuario

4

System Schematic Diagram

The following schematic diagram shows a typical IntelliChlor
Note: Refer to the relevant portions of this Installation and User's Guide for information regarding proper
placement and spacing of all equipment depicted in the schematic diagram shown below. The schematic
diagram is not drawn to scale. .
Install Chlorine/Bromine Feeders after the IntelliChlor
- To avoid permanent damage to the IntelliChlor SCG cell, in-line chlorine/bromine feeders
CAUTION
(such as Pentair Aquatic Systems Rainbow
shown below. When using the IntelliChlor SCG with an in-floor cleaning system, it is recommended that a
separate return line be used for the cleaner to reduce the increased water pressure stress on the IntelliChlor cell.
Pool pump and Power
center MUST be wired to
ON/OFF switch together.
24-hour pool pump timer,
switch or controller
(*) IntelliChlor
115/230 VAC
electrical power
supply
Automatic
Chlorine/Bromine
Feeder
Return to Pool
Not to scale
®
IntelliChlor Salt Chlorine Generator Installation and User's Guide
®
models) MUST be installed AFTER the IntelliChlor SCG cell as
IntelliChlor SCG Power Center. Provdied VDC
electrical supply (see IntelliChlor SCG Power Center
Installation Guide P/N 520590)
Heater **
SCG
cell
Pump
From Pool
IntelliChlor SCG System Schematic Diagram
® SCG system installation.
® SCG Cell
Note: (*) Install IntelliChlor SCG cell
To Drain
(Backwash)
Filter
Note: For best flow
sensing, provide at least
12"-18" of straight pipe in
front of the cell inlet.
vertically for best performance.
(**) The IntelliChlor SCG should
be at least three (3) feet away
from the heater outlet.