Safety Warnings for
Hydropneumatic Equipment
Appropriate Use
• The equipment is a stationary device designed to pump
clean neutral liquids that do not contain suspended
abrasive solids with temperature not higher that 104 °F
Any other type of use is inadequate.
• The device is in compliance with the most current safety
requirements, provided it is used for purposes originally
designed for. The device shall only be used under the
performance restrictions allowed.
• It shall not be used to pump explosives, fuel or
aggressive materials nor health damaging substances or
sewer water.
• The device is designed for household use. It is not
adequate for commercial or industrial use.
• Inadequate use or modifications to the device may result
in unforeseen damage to the device and the operator, and
releases the manufacturers of their legal responsibility.
CAUTION
• Do not set up the equipment outdoors
or close to wet areas.
WARNING
• Do not install the device in areas
where there is danger of explosion or in the vicinity of
combustible liquids or gases.
• Do not direct the water jet against the
WARNING
device or other electric devices. There is danger of death
due to electric shock.
• Double check the power cable is not
CAUTION
making contact with water circulating around the device.
• Any type of repairs shall be carried out only in a
Authorized Service Center.
Otherwise, the user is exposed to electric shock and makes
the Warranty void.
• Do not remove or cover the symbols attached to the
device. All information about the devise that is no longer
legible shall be replaced immediately.
• Read and obey the operation instructions before
installing and starting the equipment. Any malfunction
caused by disregarding the instructions in this manual may
damage the equipment and makes the Warranty void.
• When the equipment is used into pools or ponds, the
pump shall be connected through RCCB (Residual Current
Circuit Breaker) designed with a current short circuit not
higher than 30 mA
ENGLISH
5