Operation; Works Before Initial; Check The Screw; Release The Transport Lock - HOLZMANN MASCHINEN MKS 180 Manual De Instrucciones

13

OPERATION

13.1 Works before initial

13.1.1 Check the screw

Before commissioning, check that all screws are tightened and tighten them if necessary after.
Check that the safety cover is in perfect condition.
13.2 Operation
Beware of unintentional starting of the machine! Therefore, disconnect from any retooling
the machine from the mains!

13.2.1 Release the transport lock

Loosen the transportation lock pin by gently pulling on the handle (1) downward, pull out the
safety pin Fig. F. The saw head is moved by the return spring upward.
Fig. E

13.2.2 On / Off

Turned on by pressing the Start Backup button (2) Figure G and simultaneously pressing the
trigger switch (12) on the handle (1)
Fig. G
Off is done by releasing the trigger switch (12) on the handle. The machine turns off.
CAUTION: Be sure to stop the saw blade after turning off!

13.2.3 Clamping the workpiece

With the quick release vise, you can bring the front jaw to the desired position quickly.
Pull the thread lever (13) upwards.

Now you can slide it into the desired position, the front clamp by lifting the hand wheel (11).

Lower the threaded rod down and press the thread lever (13) on the threaded rod until it

clicks Fig. J
Fig. I
Place the workpiece on the rear back stop.

Clamp the workpiece firmly by turning the handwheel (11) clockwise.

HOLZMANN MASCHINEN GmbH
Fig. H.
Fig.
Fig. J
www.holzmann-maschinen.at
W A R N U N G
Fig. F
Fig. H
I.
OPERATION
19
MKS180