Maintenance; Changing The Metal Blade - HOLZMANN MASCHINEN MKS 180 Manual De Instrucciones

Clean your machine regularly after every usage – it prolongs the machines lifespan and is a pre-
requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
After each shift the machine and all its parts must be thoroughly cleaned by the chips and other
waste to be disposed.
Check regularly that all warning and safety instructions on the machine and available in a
perfectly legible condition.
Check before every use the perfect condition of the safety devices.
For storage of this machine may not be stored in a humid room and must be protected from the
influence of weather conditions.
Before first use, and then every 100 hours all movable connecting components (if necessary
before cleaning with a brush of chips and dust) with a thin layer of oil or grease grease.
The elimination of defects does your dealer.
Repair work may only be performed by qualified personnel!

14.1 Maintenance

Follow all of the conversion work in isolation from the mains!

14.1.1 Changing the metal blade

CAUTION: Use when changing the saw blade suitable safety
 Peel off the protective cover by gently turning the two screws with
an Allen wrench M
 Remove the protective cover.
 Press the shaft lock (14) down by Fig. N can easily rotate into place
the metal blade to the shaft lock. Hold down the shaft lock!
While the shaft lock is pressed solve with an Allen wrench by turning
the screw counterclockwise
 Remove the allen screw, washer and the outer blade flange
 Pay attention that the inner flange remains on the shaft.
Pull the blade guard back cover Fig. P

Remove the blade.

During installation, these steps are run in reverse.
Caution: However, make use of the direction of the saw blade in!
HOLZMANN MASCHINEN GmbH
N O T I C E
Fig. O
www.holzmann-maschinen.at
MAINTENANCE
gloves.
Fig. M
Fig. N
Fig. O
Fig. P
21
MKS180