Lotus SmarTime 50037 Manual De Usuario página 9

This product should not be worn when show-
ering or used in a sauna/steam room as it is
not possible to prevent steam entering the
watch. Any water damage to the product due
to non-compliance to this instruction will not
be covered by the warranty.
I. Functions
introduction
1.1 Buttons
A: Press the button to return to the Dial in-
terface from the Function interface; press the
button to turn on / turn off the screen when
on the Dial interface. Long press the button
to power on / power off the smart watch.
B: Press the button to enter into the multi-
sports mode.
1.2 Charging Guide
La carga magnética se muestra a continuMag-
netic charging is as shown below. This watch
supports a PC USB or 5V charger. It takes about
2 hours to fully charge the battery.
Simultaneous contact of the two pins of
the USB cable and the conductor may cause
a short circuit and may cause burning.
1.3 Shortcut function introduction:
1) Swipe from right to left on the dial interface
to enter the Data menu, which shows steps,
distance, calories. Swipe left again to enter
into the heart rate testing. Swipe left again to
enter the Sleep Monitoring function.
2) Swipe down to view certain shortcut func-
tions and settings.
3) Swipe from left to right for your daily notifi-
cation history. Follow the instruction to set up
the Bluetooth connection between the watch
and the mobile phone in order to receive mo-
bile phone notifications.
4) Swipe up to enter into the Menu interface:
here you swipe up and down to select any
functions. Tap to enter.
5) Long press on the DIAL interface to select
the DIAL, swipe left or right to select and tap
to confirm.
1.4 Down slide menu
the DIAL interface to enter into this menu)
1) Date, Bluetooth connect status, power, time.
2) Power on and power off.
3) Power on and power off;About, shows
FW version and MAC.
4) Stopwatch.
5) Brightness adjustment.
6) Settings.
1.5 Notification
Conecte el reloj a la aplicación Lotus (en ade-
Connect the watch to the Lotus application
(hereafter APP) and once in the APP ensu-
re that the necessary mobile phone permis-
sions have enabled. The device can synchro-
nize the last 10 notifications from the mobile
phone.
1.5.1. Incoming call notification
Activate "Incoming call" in the APP and the
watch will display the number as well as vi-
brate when there is an incoming call.
1.5.2. Messages notification
Turn on "SMS" in the APP. A pop-up message
notification will appear and the watch will vi-
brate when there is incoming message.
1.5.3. Others APP notification
Turn on the corresponding APP notifications in
the APP, such as the Outlook, Facebook,etc. no-
tifications. The respective corresponding APP
notifications pop-up on the watch when there is
activity on the chosen APPs.
(Slide down
9