Introduction
!
WARNING
Read this Manual BEFORE using this equipment.
Failure to read and follow all safety and use information
can result in death, serious personal injury, property
damage, or damage to the equipment.
Keep this Manual for future reference.
If you are unsure about installing your Watts filter system contact
a Watts representative or consult a professional plumber.
You are required to thoroughly read all installation instructions
and product safety information before beginning the installa-
tion of this product. FAILURE TO COMPLY WITH PROPER
INSTALLATION AND MAINTENANCE INSTRUCTIONS
COULD RESULT IN PRODUCT FAILURE WHICH CAN
CAUSE PROPERTY DAMAGE, PERSONAL INJURY AND/
OR DEATH. Watts is not responsible for damages resulting
from improper installation and/or maintenance. Local building or
plumbing codes may require modifications to the information pro-
vided. You are required to consult the local building and plumbing
codes prior to installation. If this information is not consistent with
local building or plumbing codes, the local codes should be
followed. Save manual for future reference.
Refer to the enclosed for operating parameters to ensure proper
use with your water supply.
NOTICE
Watts is not responsible for the failure of alerts due to connectivity
or power issues.
If this equipment, or any of its parts, becomes damaged
or needs repair, stop using the equipment and contact an
experienced service individual immediately.
• Use only lead-free solder and flux for sweat-solder connec-
tions, as required by state, province and federal codes.
• Handle all components of the system with care. Do not drop,
drag or turn components upside down.
• Be sure the floor under the system is clean, level and strong
enough to support the system while in operation.
• Install the system in a protected area.
• Do not attempt to treat water over 125°F (51°C) with the system.
• Always connect the system to the main water supply pipe
before the water heater.
• Do not expose the system to freezing temperatures. Water
freezing in the system causes equipment damage.
• Do not install in direct sunlight. Ultraviolet rays from the sun
may cause damage.
• A 5 micron disposable cartridge filter may be required as a
prefilter to this system to prevent premature clogging of the
BB-S101 system filter cartridge by sediment.
!
WARNING
Do not use with water that is microbiologically unsafe or of unknown
quality without adequate disinfection before or after the system.
System certified for cyst reduction may be used on disinfected
waters that may contain filterable cysts.
Table of Contents
Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
System Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Limited Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
NOTICE
Refer to quick start guide included with the
Model BB-M101 Volumetric Flow Monitor
for information on set up and registration. A
QR Code is also available for full installation
instructions.
CAUTION
!
Test the water periodically to verify that the system is
performing satisfactorily.
3