Motion BLINDS CM-40 Manual página 33

11 Move to favorite position
To move your blind to the favorite position the blind has to be at a
different position than the favorite position.
Pull control: Pull and hold to move the
blind to the favourite position.
3 s
12 Reset the favorite position
Pull control:
Hold the pull for 3 seconds to move the blind to
12.1
the desired favorite position.
Hold the pull for 7 seconds to remove the favorite
12.2
position.
Move the blind to a new desired favorite position for
12.3
slide and tilt.
Pull and hold the chain for approximately
12.4
7 seconds until the blind slides left and right.
M O TI O N CM - 4 0 D C V E R TIC AL MOT OR
12.1
12.2
12.3
12.4
Remote control: Hold the centre button to
move the blind to the favourite position.
Center
Remote control:
Move the blind to a new desired favorite position.
Press the program button on the motor to activate
program mode. The blind starts stepping.
Hold the center button to save this favorite position.
The blind shortly stops stepping indicating the
favorite position has been saved succesfully.
Press the program button on the motor to de-activate
program mode. The blind stops stepping.
15