Resistance Measurement - LaserLiner MultiMeter Manual De Instrucciones

9

Resistance measurement

To measure resistance, set the
rotary switch to the "Ω" position
with the corresponding measuring
range (200 Ω - 2 MΩ).
Then connect the measuring
contacts to the object to be
tested. The measured value
acquired appears on the display.
black
If "1" appears on the display instead of a measured value, either the
measuring range has been exceeded or the measuring circuit is not
closed or has been interrupted.
Resistances can only be measured correctly in isolation; therefore,
the components might need to be disconnected from the remainder
of the circuit.
!
When measuring resistance, to avoid the risk of the results
of a measurement being distorted, there must be no traces of
dirt, oil, solder spray or other contamination on the test prods.
2
200
m
2M
red
MultiMeter
300
200
20
200
k
20k
2k
200
= 17.28 kΩ
300
200
2000
μ
20m
200m
10A
BAT.
1.5V
BAT.
9V
21
EN