Publicidad
Idiomas disponibles
Idiomas disponibles
1 - SAFETY WARNINGS
CAUTION – to ensure personal safety it is important to follow these instructions and keep them
for future reference.
Read the instructions carefully before proceeding with installation. The design and manufacture of the
devices making up the product and the information in this manual are compliant with current safety
standards. However, incorrect installation or programming may cause serious injury to those working on or
using the system. Compliance with the instructions provided here when installing the product is therefore
extremely important. Warning: any use other than as specified herein or in environmental conditions other
than as stated in this manual is to be considered improper and is prohibited.
2 - INTRODUCING THE PRODUCT
RADIO RECEIVERS
The Key Automation RXME radio receiver is a 2-output receiver with external terminal board.
Attention: the RX4Z receiver CANNOT be managed by the XRMANAGER device.
CODE
DESCRIPTION
RXME
External receiver, 2 outputs 433.92 MHz. Maximum memory capacity 250 codes
2.1 - TECHNICAL SPECIFICATIONS
TECHNICAL SPECIFICATIONS
Decoding
Frequency
Power
Idle consumption
Max consumption
Input impedance
Relay outputs
Sensitivity
Relay contact
Operating temperature
3 - PRELIMINARY CHECKS
WARNING - before installing the product, perform the following checks and inspections:
• Check that the intended mounting surface is solid and does not allow vibrations
• Use electrical connections suitable for the currents required
• Check that the power supply conforms to the values in the technical specifications
• Connect a type ANTS433 antenna; without an antenna, the range is cut to a few metres. The
antenna must be installed as high up as possible and above any metal or reinforced concrete
structures. The antenna cable must be type RG58 and no more than 10 metres long.
• If it is not possible to fit an antenna, the range can be increased significantly by connecting an
electric cable and keeping it straight.
4 - INSTALLING THE PRODUCT
CAUTION: The factory-set RXME receiver is powered at 24V and can store up to a maximum
of 250 codes. Each key on the remote control corresponds to a code.
RXME
ROLLING/FIX CODE
433.92 MHz
12-24 Vac / Vdc
25 mA
50 mA
50 Ω
2
-93 dB
Clean contact 2A 60Vdc / 2A 120Vac
-20°+55° C
EN
5
Publicidad
