Publicidad
Idiomas disponibles
Idiomas disponibles
4.1 - MEMORISING A REMOTE CONTROL
WARNING: When the memorisation phase is activated, any transmitter within the reception range
may be memorised. To reduce the receiver's range, disconnect the antenna temporarily.
PH.
DESCRIPTION
1
Press the P button of the receiver to select relay 1
The R1 LED starts flashing. To switch to relay 2 press the P
2
button again, the R2 LED starts flashing.
After selecting the desired relay, press the button of the
remote control you want to record and keep it pressed until
3
the R1, R2 and RX LEDs remain on steady a few seconds
may pass before the receiver decodes the new code.
Repeat the operation for all the codes you want to enter in
Note
the receiver.
4.2 - DELETING A REMOTE CONTROL
PH.
DESCRIPTION
1
Press the P button of the receiver, the R1 LED starts flashing
2
Press the S button of the receiver
3
The R1, R2 and RX LEDs light up steadily
Press and hold down the button of the remote control button
4
that you want to delete until all the LEDs turn off. The remote
control has been successfully deleted
Note
Repeat the operation for all the codes you want to delete
4.3 - CLEARING THE RECEIVER MEMORY/RECEIVER RESET
PH.
DESCRIPTION
1
Press and hold the P and S buttons for about 10 seconds
Wait until the R1, R2 and RX LEDs flash quickly, then
2
release the buttons
4.4 - RELAYS CONFIGURATION
The relays are configurable in four different modes:
• Bistable: the state of the relay is maintained until another pressure of the associated remote control.
When the button of the remote control is pressed, the relay contact closes, the next time it is pressed, it
opens. ATTENTION: the absence of power supply returns the output to its rest state, i.e. open contact.
• Impulsive (factory setting): the relay contact remains closed for the entire duration of the pressure
6
EXAMPLE
P
R1
2s
EXAMPLE
P ►
R1
S
R1+
R2+
RX
EXAMPLE
P +
S > 10 sec
R1+
R2+
RX
Publicidad
