Publicidad
Idiomas disponibles
Idiomas disponibles
User instructions
User instructions
NOTICE!
Before each use
CHECK HUMIDIFIER PLACEMENT – Place the Humidifier on a non-
metallic, lint free, waterproof, level surface for best performance.
This is to help disperse the mist in the air and prevent it from being
knocked or tipped over.
CAUTION!
DO NOT operate the humidifier without water in the water tank.
DO NOT plug in the power supply cord with wet hands; electric
shock could happen.
− Be sure the humidifier is turned OFF and the humidifier is
unplugged from the electrical outlet.
− Select a location for your humidifier on a flat surface
approximately 4 inches away from a wall.
− DO NOT place the humidifier on a finished floor or near
furniture which can be damaged by moisture or water. Place
on a water resistant surface.
− DO NOT place humidifier on top of a towel, or a carpeted
surface. This may cause the humidifier to overheat.
− DO NOT place humidifier on a wood surface.
14
Operation
1. Lift water tank (p. 3, fig. A
2
) off of base holding bottom of tank with both
hands.
2. NOTE: DO NOT hold water tank by handle (p. 4, fig. 2
3. Turn tank upside down and unscrew water tank cap (p. 4, fig. 3
counterclockwise.
4. Fill water tank with cold water. Do not fill all the way to the rim.
5. NOTE: If you have hard water, it is recommended to use filtered or distilled water.
While using the humidifier, if you see a film of white dust, it is because of hard
water.
6. DO NOT add any medication or other additives into the water tank itself. For use of
essential oils, see page 17.
7. Screw water tank cap back onto tank by turning clockwise.
8. Place tank onto the base (p. 3, fig. A
base. There should not be a space between the tank and base.
9. Place mist lid (p. 3, fig. A
1
) on top of water tank and turn mist lid to face
desired direction of the mist.
10. NOTE: DO NOT move humidifier while water tank is on base. Water may leak into
the base causing a malfunction.
11. Plug the power cord into an electrical outlet. DO NOT use an extension cord.
12. Turn power on by turning the control knob (p. 4, fig. 5
right). You will hear a minor clicking noise when turning unit on and off. The
green power indicator light will turn on.
13. In a few moments, the mist will start coming through the mist lid. Use the control
knob to adjust the intensity of the mist output. Turning the knob clockwise will
increase the moisture output, turning the knob counterclockwise will reduce the
moisture output.
14. Note: When at maximum level, it is normal to hear a faint dripping sound.
15. Turn on the blue unit LED night light by pressing the 'LED On/Off' button (p. 4,
fig. 5
14
or
15
). To turn it off, press and hold the button for 2 seconds.
3
) when empty or full.
5
) by turning it
3
). Make sure it is laying flush into the
12
) clockwise (to the
Operation
15
Publicidad
Solución de problemas
