Publicidad
Idiomas disponibles
Idiomas disponibles
15.3
Hand bandsaw set-up procedure
Machine must be switched off, engine must be stopped and should be secured
against unintentional starting by disconnecting the spark plug connector.
HOLZMANN Maschinen GmbH
WARNING
www.holzmann-maschinen.at
1.
Adjust cutting height position
Before turning the chain handle to move the
saw unit up and down, first loosen the locking
handles on the two guides. When you reach
the desired position, tighten them again.
2. Check the belt tension:
The belt tension is controlled by hand and if it
is possible to push it more than 10cm, the belt
should be tightened.
3. Check blade tracking
4. Check blade guide adjustment
CAUTION
Slide the blade guide over the blade so
that only the required cut distance
remains free.
5. Check saw blade tension:
Proper blade tension is achieved if the blade
defects no more than 3-6 mm when it is firmly
moved by hand at the center location of the
blade.
6. Check level of lubrication tank and refill if
necessary.
NOTICE
Use only water with a light detergent
(soapy liquor; Washing up) as a coolant.
OPERATION
48
BB810SMART-G
Publicidad
