EN Operating instructions
The TILT Y axis function is active. The following functions can be invoked:
Use the
tage values for the Y axis.
Use the
set tilt values are retained but do not appear in the display.
Use the
NOTE
f The
of the percentage values. For a description, see Chapter 8.2, Page 37.
f The most recently set tilt values are saved when the laser is switched off and the
next time the TILT function is started, these set values are shown in the display as
default values.
NOTE
The TILT alarm function is switched on after 30 seconds. The laser detects a large
vibration and triggers the warning message C01. With the Primus 2 H1N+, small
vibrations are detected and corrected for by the automatic feature, so that the exact
set tilt is retained for a longer period.
button to invoke the TILT function again and change the percen-
button to switch to MANUAL operating mode (Chapter 7.2). The
button to exit the operating mode, switch off the laser.
buttons are equipped with comfort functions for fast and precise setting
31