Block Diagram - HH TESSEN TNA-2120SA Manual Del Usuario

TNA ACTIVE LINE ARRAY SYSTEM
CONTROL PANEL
LOUDSPEAKERS
FULLRANGE - A
MIN 4 OHMS
FULL RANGE - B
MIN 4 OHMS
11. FULL RANGE - A/B: Two high power outputs via speakON compatible connectors.
Each output is driven via its own amplifier channel and is capable of driving into a 4 Ohm load or greater.
Always connect the LOUDSPEAKER-A OUTPUT to the Input of the TNA-205I which is physically closest to the TNA-2120SA. The
DSP Presets have taken proximity into account and offer subtle differences in the FULLRANGE A and B outputs.
12. POWER SWITCH: Turns the system On and Off. Ensure the VOLUME control is set to minimum when switching the unit On or
Off.
13. TWIST LOCK MAINS POWER INLET:
universal mains power supply, and will operate from 100V~ to
240V~. Ensure the mains cable is earthed.
14. VENTILATION SLOTS: To ensure prolonged and
reliable use. DO NOT block or obstruct the ventilation slots
on the rear panel.
15. PLEASE OBSERVE THE PANEL SAFETY
WARNINGS!
(speakON and powerCON are registered trademark of Neutrik AG.
All other trademarks are the property of their respective owners)

BLOCK DIAGRAM

INPUT
+
2
VOLUME
2 1
3
-
3
LINK OUT
2
1 2
3
3
© 2022 HH Electronics Ltd
11
WIRING
± 1 INPUT
± 2 N/A
Connect the included PowerCON compatible mains lead here. The
1 4
2 5
3 6
0 10
LIMITER
DSP PRESETS
HIGH-PASS FILTER
LOW-PASS FILTER
BAND-PASS FILTER
Designed and Engineered in the UK by HH Electronics LTD.
MODEL: TNA-2120SA
12
SN:ABC1234567890
13
14
14
LIMITER
(LINE OUT)
(SUB OUT)
LIMITER
LIMITER
MODE
LINE OUT
SUB OUT
MODE SWITCH SELECTION
IMPACTS FREQUENCY RANGE
OF THE INTERNAL WOOFERS.
LIVE SOUND & INSTALLATION
POWER
I
0
POWER CONSUMPTION 250 WATTS 50/60Hz
SUPPLY VOLTAGE ~100V-240V
TNA-2120SA
3 CHANNEL POWER AMP
INTERNAL SUB-WOOFERS
CHANNEL 1
CHANNEL 2
FULLRANGE - A
CHANNEL 3
FULL RANGE - B
SUB OUT
2
1 2
3
3
OFF
GROUND LINK
ON
EN
EN
contains a
15
7