Cardin RCQ504W00 Serie Manual Del Usuario página 22

• The DKS devices are suitable for outdoor use (IP57).
• The DKS devices must be positioned in sight, away from moving parts and at a height of at least 1.5 m.
• Caution! In order to avoid a reduction in the transmission range of the DKS transponder device never install it directly on metal
structures.
Installing the transponder reader DKSTPT (fig. 5)
• Once you have decided on the definitive position, unscrew the two holding screws "1" and separate the base "2". Pass the connecting
cables "3", coming from the interface, through the wall, drill two holes in the wall "3-4" and fix the fastening base to the wall using the two rawlplugs and
screws "5-6". Rotate the transponder reader "7", unscrew the two holding screws "8" and remove the cover protecting the terminal block "9".
• Pass the power supply / signal cable through the hole "10", bend it slightly "11" and wire it to the terminal block "12". Replace the terminal block cover
and fasten down using the screws "14". Rotate the transponder reader, hook it onto the upper part of the base "15" and rotating it slightly allow it to
snap onto the base "16", then fasten the reader using the two screws "17".
Installing the keypad with transponder reader DKSDUALT (fig. 6)
• Once you have decided on the definitive position, unscrew the two holding screws "1" and separate the base "2". Drill the wall "3" fix the fastening base to
the wall using the two rawlplugs and screws "4-5", as shown ij the drawing. Rotate the keypad "6" and remove the six cover fastening screws "7".
• Remove the base of the keypad "8". Make a hole in the rubber gasket and pass the power/data cable through the hole "9", bend the wires slightly and fasten
them to the terminal block "10" respecting the polarity "11". Replace the keypad base "12" and fasten down using the previously removed screws "13".
• Rotate the keypad, hook it onto the upper part of the base "14" and rotating it slightly allow it to snap onto the base "15", then fasten it using the two screws "16".
Installing the keypad DKS250T - DKS250TL (fig. 7)
• Pass the connecting cables,"1" coming from the interface, through the wall. Drill the wall at the distance indicated in figure 7a (58 mm). Insert the
rawlplugs "2"supplied with the kit. Fasten down the counter plate "3" sing the screws "4" supplied with the kit. Connect the Fastons on the wires "1"
to the Fastons "5" (fig, 7a-7b). Position the keypad (fig 7b-7c) and fasten it down to the counter plate using the special screw "S1" and the tool "K1".
DKSTPT, DKS250T, DKS250TL AND DKSDUALT OPERATION
22
F E
X -
I N O
N O
Drawing number : DM1009 Description : Montaggio Transponder
a superfice INOX
Product Code : SSB-T9K4
Draft : P.J.Heath Date : 01-04-2016
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/