Progress Lighting AirPro P250095 Manual De Instalación página 10

Figure 14
Switch housing
Step 7. Insert the wires with 9-pin connectors
from the motor assembly through the center hole
in the switch housing. Attach the switch housing
to the mounting plate on the motor assembly by
placing the keyhole slots from the switch housing
onto the two protruding mounting screws heads.
Adjust the switch housing until the screw heads
are aligned with the keyholes, then re-install the
mounting screw previously removed on step 6.
Tighten all mounting screws securely. (Figure 14)
Switch housing
screw
Figure 15
7.
Step 8. Remove one of three switch housing
screws on the side of switch housing and keep for
later use, then loosen the other two. (Figure 15)
Figure 16
Step 9. Attach the light kit assembly to switch
housing. Replace the screw previously removed
on step 8. Tighten all switch housing screws
securely. (Figure 16)
Step 10. Insert two MAXIMUM 6W E26 LED
bulbs (included) into lamp holders. Dry your hands
before installing bulbs. Keeping the bulbs clean is
important as useful lifetime of a dirty bulb could be
shorter than a clean bulb. (Figure 17)
Light kit
Step 11.
assembly
twisting in a clockwise direction. Do not over-tighten.
Ligth Control
Pull Chain
Bulb
Fob
Step 12. Connect the fobs to the appropriate pull
Figure 17
chains as shown in Figure 19.
The fob marked with a fan image is for motor speed
control: High , medium , Low and off. Pull once for
each position.
The fob marked with a lamp image controls the
light, either ON or OFF with each pull of the chain.
Shade
Figure 18
Secure the shade to switch housing by
Reverse Switch
Fan Control
Pull Chain
Figure 19