Hanging The Fan - Progress Lighting AirPro P250095 Manual De Instalación

Hanging the Fan

REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
Step 1. Pass the 120-volt supply wires through
the center hole in the ceiling hanger bracket as
shown in Fig. 5.
Step 2. Secure the hanger bracket to the ceiling
outlet box with the screws and washers provided
with your outlet box.
Step 3. Remove the hanger pin, lock pin and set
screws from the top of the motor assembly. (Fig. 6)
Step 4. Route wires exiting from the top of the fan
motor through the coupling cover, decorative
cover, canopy and then through the downrod.
(Fig. 7)
WARNING
FAILURE TO PROPERLY INSTALL
LOCK PIN AS NOTED IN STEP 5
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
Step 5. Align the holes at the bottom of the
downrod with the holes in the collar on top of the
motor housing (Fig. 7). Carefully insert the
hanger pin through the holes in the collar and
downrod. Be careful not to jam the pin against
the wiring inside the
downrod. Insert the lock pin through the hole near
the end of the hanger pin until it snaps into its
locked position, and tighten set screws as shown
in Fig.7. Cut off excess fixture wires leaving
approximately 6 to 9 inches above top of hanger
ball/downrod assembly.
Ceiling hanger
bracket
Figure 5
120V wires
Hanger ball
Lock
pin
Figure 6
Downrod
Canopy
Decorative cover
Coupling cover
UL Listed
Lock pin
electrical box
Washers
Mounting screws
(supplied with
electrical box)
Figue 7
Hanger pin
6" to 9"
Downrod/ball
assembly
Hanger pin
Motor assembly
4.