Finishing The Installation - Progress Lighting AirPro P250095 Manual De Instalación

Finishing the Installation

Step 1. Tuck connections neatly into ceiling
outlet box.
Step 2. Slide the canopy up to mounting bracket
and place the key hole on the canopy over the
screw on the mounting bracket, turn canopy until
it locks in place at the narrow section of the key
holes. (Fig. 10)
Step 3. Align the circular hole on canopy with the
remaining hole on the mounting bracket, secure
by tightening the two set screws. Note: Adjust the
canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING
Make sure the notch on the hanging bracket properly
sits in the groove in the hanger ball before attaching
the canopy to the bracket by turning the housing until
it drops into place.
Canopy
Hanger
bracket
screw
Decorative cover
Step 4. Attach blade to the blade iron using three
(3) blade screws as shown in Figure 11. Repeat this
step for the remaining blades. Tighten the screws
securely.
Figure 12
Figure 10
Step 5. Attach blade assembly to the motor
assembly using 2 blade iron screws as shown in
Blade screw
Figure 12. Repeat this step for the remaining
Blade
blade assemblies. Tighten the screws securely.
Blade iron
Figure 11
Blade iron screw
Step 6. Remove one of the mounting screws on
mounting plate of motor assembly, then loosen
the other two.(Figure 13)
Blade assembly
Mounting screw
Figure 13
6.