Publicidad
Idiomas disponibles
Idiomas disponibles
English
Important Safety Instructions for All Integral Battery Charging
WARNING: Read all safety warnings, instructions, and cautionary markings
for the battery, USB cable and product. Failure to follow the warnings and
instructions may result in electric shock, fire and/or serious injury.
•
The provided USB cable is not intended for any uses other than charging
BLACK+DECKER rechargeable tools with micro USB ports. Charging other types of
tools may cause their batteries to overheat and burst, resulting in personal injury,
property damage, fire, electric shock or electrocution.
•
When charging with a computer, use only Listed/Certified Information
Technology Equipment.
•
DO NOT expose USB cable to water, rain or snow.
•
Pull by the plugs rather than the cord when disconnecting the USB cable. This will
reduce the risk of damage to the plugs and cord.
•
Make sure that the cord is located so that it will not be stepped on, tripped over or
otherwise subjected to damage or stress.
•
When charging the tool outdoors, always provide a dry location.
•
DO NOT use a USB cable with a damaged cord or plugs. Have them
replaced immediately.
•
Foreign materials of a conductive nature, such as, but not limited to, grinding dust,
metal chips, steel wool, aluminum foil or any buildup of metallic particles should be
kept away from the USB and micro USB plugs and port.
•
Always unplug the USB cable from the power supply when there is no tool
attached to it.
Charging Procedure (Fig. B)
WARNING: Do not use tool while it is connected to the charger.
1. Insert the charging cable
2. Plug the other end of the charging cable into any compatible port (such as on a computer).
The green charging LEDs
‑
One will flash with a low charge.
‑
Two will flash with a medium charge .
‑
Three will flash with a high charge.
‑
All LEDs will remain on when tool is fully charged.
3. Battery can be left charging or charger can be disconnected.
10
10
into the charging port
9
will flash.
8
.
Publicidad
