Publicidad
Idiomas disponibles
Idiomas disponibles
briefly disconnected for this device when the batteries are
changed. If, for example, only the batteries in the sensor
are replaced, the signal may subsequently not be received
at all or not be received correctly.
Note that the actual range depends on the respective con-
struction materials used for the buildings as well as the re-
spective position of the base unit and the outdoor sensor.
External influences (various radio transmitters and other
sources of interference) can greatly reduce the possible
range. In such cases, we recommend finding other locations
for both the base unit and the outdoor sensor. Sometimes
moving the sensor by just a few centimeters is enough!
Though the remote unit is weather proof, it should be
placed away from direct sunlight, rain or snow.
7 Setting up power supply
Base unit
1.
2.
3.
4.
Wireless sensor
5.
6.
7.
8.
9.
10 / 100
Remove the battery compartment cover.
Insert batteries into the battery compartment. Make
sure that the batteries are correctly aligned (+/- poles).
Replace the battery compartment cover.
Wait until indoor temperature is displayed on the base
unit.
Remove the battery compartment cover.
Move the CH slider to the position for the desired trans-
mission channel (setting CH1, CH2 or CH3 with indica-
tion on the display).
Insert batteries into the battery compartment. Make
sure that the batteries are correctly aligned (+/- poles).
Replace the battery compartment cover.
Press the SET button for approx. 2 seconds.
Publicidad
