Battery Details - WowWee FlyTech CRASH FX 4705 Manual Del Usuario

batterY details

battery details
The Crash FX remote controller requires 4 x "AA" size batteries (not included) .
Install the batteries as follows:
1 . Open the battery compartment on the remote controller using a Phillips
screwdriver (not included) to remove the screw on the battery compartment cover .
2 . Insert the batteries according to the diagram . Ensure that the positive and
negative polarities match the illustrations inside the battery compartment .
3 . Replace the battery compartment cover and replace the screw using the
screwdriver . Do not over-tighten .
Important Battery Information
• Use only fresh batteries of the required size and recommended type
• Do not mix old and new batteries, different types of batteries [standard (Carbon-Zinc), Alkaline
or rechargeable] or rechargeable batteries of different capacities
• Rechargeable batteries are only to be charged under adult supervision
• Please respect the correct polarity, (+) and (-)
• Do not try to recharge non-rechargeable batteries
• Do not throw batteries into the fire
• Replace all batteries of the same type/brand at the same time
• The supply terminals are not to be short-circuited
• Remove exhausted batteries from the remote controller
• Batteries should be replaced by adults
• Remove batteries if the remote controller is not going to be played with for some time
• Rechargeable batteries are to be removed from the remote controller before being charged
4
1.5V 1.5V 1.5V 1.5V
LR6 LR6 LR6 LR6
UM3 UM3 UM3 UM3
"AA" "AA" "AA" "AA"
Battery
compartment
door
6V