Publicidad
Idiomas disponibles
Idiomas disponibles
Charging Crash FX
Before using Crash FX for the first time, or if you have depleted the charge, you will
need to recharge it . This usually takes about 10 minutes and gives up to 5 minutes
of play . If the charge time begins to exceed 15 minutes, replace all of the batteries
in the remote controller with fresh batteries .
To charge Crash FX, do the following:
NOTE: Verify that Crash FX is turned OFF before you charge it .
1 .
Pull out the charger cable located on the bottom side of the remote controller .
2 .
Insert the charger cable into the socket on
Crash FX, as illustrated .
3 .
Slide the power switch on the remote controller to CHG . If the
connector on the cable is properly connected to the socket,
the LED indicators on the remote controller will pulse slowly to
indicate it is charging properly .
4 .
When Crash FX is fully charged, the LED indicators will blink twice
and then pause before blinking again .
CHarGinG CrasH FX
5
Publicidad
