oPeratinG CrasH FX
operating Crash FX
It is best to use Crash FX in large room at least 20 x 20 feet (6x6m) . Turn off air
conditioner units and fans, and close any open windows in order to create a still
environment in which to fly your Crash FX . You might want to keep any pets out of the room .
IMPORTANT: Do not use Crash FX outdoors or near water .
IR Band
Crash FX is available in two infrared (IR) bands, enabling you to fly two Crash FXs
of differing IR bands, each with independent control . Before you use Crash
FX, set the remote controller to the correct band using the IR band selector .
If your Crash FX is red, select A . If your Crash FX is blue, select B .
You can also check the packaging to see what band your Crash FX is .
Operating Crash FX
To operate Crash FX do the following:
1 .
Turn the remote controller on by setting the power switch to ON .
The LED indicators will light up and remain lit .
2 .
Turn Crash FX on by setting the power switch to ON . The LED signal indicator
will light up .
3 .
Launch Crash FX
from your hand .
4 .
Push the throttle to control the height and
speed of Crash FX; push the direction toggle
left or right depending on which way you
want to turn .
NOTE: Always point the remote controller
directly at Crash FX .
6
A - B
Chg On OFF