Trigger Input - Bellman & Symfon BE1431 Manual De Instrucciones

Transmitter Receiver signal pattern
Switch Source LED
Landline/test button 3 x yellow blinks
Mobile phone sensor Yellow light
Other accessory 3 x orange blinks
Landline/test button Orange blinks
Mobile phone sensor 3 x yellow blinks
Other accessory Green blinks
Landline/test button Orange/Red blink
Mobile phone sensor Orange/Red blink
Other accessory Orange/Red blink
Landline/test button Red blinks
Mobile phone sensor Red blinks
Other accessory Red blinks
156
Sound Vibration Flash
1 x ring signal, high Medium Yes
1 x ring signal, low Medium Yes
Baby melody Fast Yes
Baby melody Fast Yes
1 x ring signal, high Medium Yes
2 x door chime, high Slow Yes
VMA Long Yes
VMA Long Yes
VMA Long Yes
Fire alert Long Yes
Fire alert Long Yes
Fire alert Long Yes

Trigger input

You can use both stereo and mono plugs. The 3.5 mm input is located on the top right
side and the 2.5 mm input under the lid.
Mono
Trig is made by closing the two connectors
Stereo
Trig is made by:
1 Closing the outer and middle connector or closing the
outer and inner connector
2 Applying 2-30VDC or 3-24VAC 5-150Hz between the
middle and inner connector
Please note that when you use the 2.5 mm ext trig, the event must last for more
than 2 seconds
157