Publicidad
Idiomas disponibles
Idiomas disponibles
LS103Ec
5.3 Transverse guide fence adjustment
The transverse guide fence permits the distance between the tenon hole and the exterior side to be adjusted
continuously between 8 and 150 mm [0.31 - 5.90 in].
Use the following procedure to adjust the
transverse guide fence:
1.
Loosen the clamping lever (8) for the
transverse guide fence.
2.
Adjust the transverse guide fence.
The distance is indicated on the scale
➢
(7). Observe the indicator edge, it
depends on the hole width 30, 35 or
40 mm!
3.
Tighten the clamping lever (8) for the
transverse guide fence.
The clamping lever is adjustable. Pull it
➢
upwards to move it to the required
clamping position.
Transverse guide fence adjusted.
✓
5.4 Mortise depth adjustment
The mortise depth can be adjusted continuously. The mortising depth depends on the currently used chain
cutter assembly.
Use the following procedure to adjust the
mortise depth:
1.
Loosen the clamping lever (4) for the mortise
depth adjustment.
2.
Using a meter stick, adjust the depth stop (5)
to the required depth.
3.
Tighten the clamping lever (4) for the mortise
depth adjustment.
➢
The clamping lever is adjustable. Pull it
upwards to move it to the required
clamping position. Do not set the
clamping lever in the mortise direction!
Mortise depth adjusted.
✓
02/2022
Fig. 11: Adjusting the transverse guide fence
Fig. 12: Adjusting the mortise depth
15
Publicidad
