Publicidad
Idiomas disponibles
Idiomas disponibles
5.5 Working information
To mortise, hold the machine at both handles.
The transverse guide fence must be in contact with
the workpiece.
Do not start mortising the workpiece before the
cutting chain has reached its full rotational speed.
Mortise at uniform pressure and feed rate.
Position the machine for mortising when the cutting
chain is running. Start with mortising the beginning
and the end of the tenon hole, then do the rest.
The dimensions of the tenon holes depend on the
currently used chain assembly. In the standard
version, these are 28x40x100 mm [1.10x1.57x3.94
in].
The hole length L is 28 mm [1.10 in].
The hole width W is 40 mm [1.57 in].
The mortise depth is adjustable up to 100 mm [3.94
in]. For this, see the information in chapter 5.4
Mortise depth adjustment.
5.6 Mortising recesses
The transverse guide fence has several boreholes
(15) with a ø of 4.5 mm [0.18 in]. They can be used
to secure wooden slats on them.
This makes it possible to mortise recesses at the
workpiece.
16
Fig. 13: Mortising a tenon hole
Fig. 14: Tenon hole dimensions
Fig. 15: Boreholes at the transverse guide fence
LS103Ec
02/2022
Publicidad
