Publicidad
Idiomas disponibles
Idiomas disponibles
LS103Ec
3.4 Specific safety rules
Sawing method
- Ensure that you stand in an unobstructed and non-slip area with adequate lighting.
- Always pull out the power plug before you change tools, make adjustments, or eliminate malfunctions (this
also includes removing trapped chips).
- Never work on workpieces that are too small or too large for the machine capacity.
- Mount cutting chain and guide rail properly and keep them in order. Prior to reusing a defective cutting
chain, repair it properly. Use only sharp cutting chains!
- Use only type 100 cutting chain assemblies for a machine without FG 150 guide rack!
- Remove the chain guard only for tool change. Screw it back on immediately afterwards. Never work without
chain guard!
- Never transport the chain mortiser with cutting chain running. Avoid any contact of the running cutting chain
with the soil!
- Never clamp the switch.
- Prior to switching on the machine check to ensure that the cutting chain is properly tensioned.
- Whenever possible, secure the workpiece, for example with screw clamps, against swinging away, slipping,
tipping over or bobbing up.
- Do not start mortising the workpiece before the cutting chain has reached its full rotational speed.
- Check the workpiece for foreign bodies. Never mortise into metal parts, such as nails.
- Hold the machine with both hands before you switch it on.
- Switch on the machine only when there is not contact between the cutting chain and the workpiece. Position
the machine for mortising when the cutting chain is running.
- While you are mortising, ensure that the connecting cable always runs towards the rear, away from the
machine.
- Adjust the mortising feed rate to the material thickness. Mortising too quickly will overload the motor, results
in improper mortises, and causes the cutting chain to be blunt more quickly.
- Do not remove the machine from the workpiece before the cutting chain has stopped.
- Never reach into the chip ejector and into the unprotected area of the cutting chain while the machine is
running.
- Before switching on the machine during freehand milling, make sure that the transverse guide fence is
fastened and is in contact with the workpiece. Do not mill without the transverse guide fence!
- Only use the machine outdoors or in well ventilated rooms.
02/2022
RETAIN THESE INSTRUCTIONS!
9
Publicidad
