Publicidad
Idiomas disponibles
Idiomas disponibles
K65cc/KSS60cc
Use the following procedure to preset the
plunge depth:
1.
Using the plunge lever (1), set the machine to
the desired plunge depth.
2.
Using the Allen key (B), open the clamping
screw (21).
The stop bar (22) drops down to the
➢
stop.
3.
Tighten the clamping screw (21).
You can make several plunge cuts with
➢
the same depth.
After you have finished with the plunge
➢
cuts with the same depth, set the stop
bar back to the upper position to achieve
the full plunge depth.
The plunge depth is preset.
✓
Use the following procedure to revert to the full
plunge depth:
1.
Using the Allen key (B), open the clamping
screw (21).
2.
Set the machine to maximum cutting depth. To
do this, move the plunge lever (1) down until it
hits the stop.
The stop bar (22) moves to the topmost
➢
position.
3.
Tighten the clamping screw (21).
The full plunge depth is possible again.
✓
01/2022
Fig. 20: Presetting the plunge depth
Fig. 21: Resetting the cutting depth
25
Publicidad
