Publicidad
Idiomas disponibles
Idiomas disponibles
K55cc/KSS50cc
Use the following procedure to install the
parallel guide fence:
1.
Loosen the wing screws (5) on both sides.
2.
Insert the parallel guide fence (C) into the
guide provided for this purpose.
It can be mounted on the left or right side
➢
of the machine.
3.
Tighten the wing screws (5) on both sides.
✓
The parallel guide fence is installed.
Use the following procedure to adjust the
cutting width:
1.
Loosen the wing screws (5) on both sides.
2.
Adjust the parallel guide fence.
3.
Tighten the wing screws (5) on both sides.
The cutting width is adjusted.
✓
In addition, the parallel guide can also be used as a double support for a better guidance
of the hand-held circular saw. Simply turn it over (the guide tab (19) points upwards).
Alternatively, you can guide the machine with the parallel guide fence along a guide rail
or a wooden ledge fixed on the workpiece. This requires the parallel guide fence to be
rotated so that the guide tab (19) points upwards.
01/2022
Fig. 20: Installing the parallel guide fence
Fig. 21: Adjusting the cutting width via the parallel guide
fence
25
Publicidad
