Techno Line WL 1035 Manual De Instrucciones página 23

•
Adjustable PM 2.5 / CO2 / TVOC high or low value alert with
optional alarm sound
•
Adjustable alert for high or low humidity
•
Automatic baseline calibration
•
Backlight with automatic adjustable brightness levels by light
sensor
•
Temperature and relative humidity
•
Mold alert and dryness indicator
•
Built-in memory chip to save settings when power is off
•
Table standing
•
1.8 m USB cable and 5V~1.2A adaptor KA06E-0501200EU as
power supply (included)
Installation
Plug in the enclosed 5V-1.2A AC/DC adaptor to an AC wall outlet
and then the DC jack of the USB cable to the back of your air
quality monitor. Connect the free ends of the USB cable with
AC/DC power adapter with each other. The display will come on
with the relevant temperature and relative humidity. Your PM 2.5/
/ TVOC readings flash with "----". The relevant data will be
CO
2
displayed in around 180 seconds. It takes 1-2 hours to have all the
data of PM 2.5/CO
readings initially stabilized.
If the AC power is interrupted, the monitor does not function, the
display and the backlight are turned off. The settings of your unit
will be kept by the internal memory chip so your monitor will
function again after the AC power resumes.
Note:

For first time use, put the monitor in a well ventilated
environment (around lowest possible value of TVOC at 0.22
3
mg/m , CO2 at 400 PPM, PM2.5 at 5 ug/m
/ TVOC, temperature and relative humidity
2
EN4
3
) for at least 12