Publicidad
Idiomas disponibles
Idiomas disponibles
minimum CO
continuous monitoring.
Make sure the place you put your monitor at is well ventilated (with
a CO
level near 400 PPM or TVOC near 0.2 mg/m
2
hour or so everyday, or you move the monitor to such a well
ventilated room for an hour or so everyday to perform Automatic
Baseline Calibration.
Note:
Please try not to place your monitor in an environment with a
TVOC concentration higher than 1mg/m
Otherwise, the sensitivity of the TVOC sensor will be reduced
or the TVOC sensor will be damaged.
Manual calibration of the PM2.5/CO
It is recommended to undergo manual calibration performed by a
qualified laboratory every 12 months.
This must be done in a well ventilated room or an environment with
clean air (ideally in a room showing lowest value of CO
PPM, TVOC at 0.2mg/m
Caution : Do not calibrate the monitor in an environment of
unknown CO
•
Power on your air quality monitor it on and wait for 3
minutes until the first PM2.5/CO
displayed.
•
Then press and hold the
flashes. Press the
to select. PM2.5, CO
and hold the
/ TVOC reading detected during 7 days of
2
3
, PM2.5 below 4 ug/m
concentration.
2
/TVOC sensors
2
/TVOC readings are
2
or the
or TVOC is displayed. Then press
2
button until "CAL" flashes.
EN11
3
) for at least an
3
for a long time.
2
3
).
button, only CO
button repeatedly
at 400
display
2
Publicidad
